Accessories from Fujifilm

The following optional accessories are available from Fujifilm. For the latest information on the accessories available in your region, check with your local Fujifilm representative or visit “Accessories”.

Rechargeable Li-ion batteries: NP-W235: Additional high-capacity NP-W235 rechargeable batteries can be purchased as required.

Dual battery chargers: BC-W235: The BC-W235 can charge up to two NP-W235 batteries at a time. At +25 °C/+77 °F, the batteries will charge in about 200 minutes. Using a device that supplies power with an outputs of 30 W or above reduces charging times to as little as 150 minutes.

Remote releases: RR-100: Use to reduce camera shake or keep the shutter open during a time exposure (φ2.5 mm).

Stereo microphones: MIC-ST1: An external microphone for movie recording.

FUJINON lenses: XF-/XC-series lenses: Interchangeable lenses for use exclusively with the FUJIFILM X-mount.; FUJINON MKX-series lenses: Cinema lenses for the FUJIFILM X-mount.

Macro extension tubes: MCEX-11/16: Attach between the camera and the lens to shoot at high reproduction ratios.

Teleconverters: XF1.4X TC WR: Increases the focal length of the compatible lenses by about 1.4×.; XF2X TC WR: Increases the focal length of the compatible lenses by about 2.0×.

Mount adapters: FUJIFILM M MOUNT ADAPTER: Allows the camera to be used with a wide selection of M-mount lenses.

Body caps: BCP-001: Cover the camera lens mount when no lens is attached.

Shoe-mounted flash units: EF-X500: In addition to manual and TTL flash control, this clip-on flash unit has a Guide Number of 50/164 (ISO 100, m/ft.) and supports FP (high-speed sync), allowing it to be used at shutter speeds that exceed the flash sync speed. Featuring support for the optional EF-BP1 battery pack and Fujifilm optical wireless flash control, it can be used as a master or remote flash unit for remote wireless flash photography.; EF-BP1: A battery pack for shoe-mounted flash units. Takes up to 8 AA batteries.; EF-X8: This compact, clip-on flash unit draws power from the camera has a Guide Number of approximately 8/26 (ISO 100, m/ft.) and can cover the angle of view of a 16 mm lens (equivalent to 24 mm in 35 mm format).; EF-42: This clip-on flash unit has a Guide Number of 42/137 (ISO 100, m/ft.) and supports manual and TTL flash control.; EF-X20: This clip-on flash unit has a Guide Number of 20/65 (ISO 100, m/ft.) and supports manual and TTL flash control.; EF-20: This clip-on flash unit has a Guide Number of 20/65 (ISO 100, m/ft.) and supports TTL flash control (manual flash control is not supported).

Vertical battery grips: VG-XT4: See “Vertical battery grips” (aVertical Battery Grips ).

Tripod grips: TG‑BT1: Record movies, take photographs, or adjust zoom on compatible power zoom lenses while holding this Bluetooth tripod grip.

Grip belts: GB-001: Improves grip. Combine with a hand grip for more secure handling.

Cover kits: CVR-XT4: A set of covers for the X-T4. Contains a sync terminal cap, a hot-shoe cover, and a memory card slot cover, as well as two vertical battery grip connector covers (one black and one silver).

instax SHARE printers: SP-1/SP-2/SP-3: Connect via wireless LAN to print pictures on instax film.