Use the built-in flash for additional lighting when shooting at night or indoors under low light.
The flash modes available vary with the shooting mode.
Press the button to raise the flash.
The flash may contact accessories mounted on the hot shoe. If necessary, remove accessories before raising the flash.
Press the function button (Fn5) to display the following options, then use the selector to highlight an option and press MENU/OK to select.
Flash options can also be accessed using the FLASH SET-UP option in the shooting menu.
Depending on the distance to the subject, some lenses may cast shadows in photos taken with the flash.
Be careful not to injure yourself on the edges of the raised flash.
If is displayed when the shutter button is pressed halfway, the flash will fire when the photo is taken.
Except in commander mode, the flash may fire several times with each shot. Do not move the camera until shooting is complete.
Red-Eye Removal
When “intelligent face detection” is active, and on is selected for “red eye removal”, red-eye removal is available in , , , . Red-eye removal minimizes “red-eye” caused when light from the flash is reflected from the subject’s retinas.
Flash Sync Speed
The flash will synchronize with the shutter at shutter speeds of 1/180 s or slower.
Optional Flash Units
The camera can also be used with optional FUJIFILM shoe-mounted flash units. Do not use third-party flash units that apply over 300 V to the camera hot shoe.