The camera can be used with lenses for the FUJIFILM X-mount.
Lens hood
Mounting marks
Focus ring
Zoom ring
Aperture ring
O.I.S. switch
Aperture mode switch
Lens signal contacts
Front lens cap
Rear lens cap
Remove lens caps as shown.
Lens caps may differ from those shown.
When attached, lens hoods reduce glare and protect the front lens element.
At settings other than [A], you can adjust aperture by rotating the lens aperture ring (exposure modes [A] and [M]).
When the aperture ring is set to [A], rotate the front command dial to adjust aperture.
Aperture ring
The Aperture Mode Switch
If the lens has an aperture mode switch, aperture can be adjusted manually by sliding the switch to 
and rotating the aperture ring.
Aperture mode switch
Aperture ring
The method used to adjust aperture can be selected using 
[BUTTON/DIAL SETTING] > [APERTURE SETTING]. When an option other than [AUTO] is selected, aperture can be adjusted using the front command dial.
Aperture control defaults to the front command dial, but can be reassigned to the rear command dial using [BUTTON/DIAL SETTING] > [COMMAND DIAL SETTING].
If the lens supports optical image stabilization (O.I.S.), the image stabilization mode can be chosen in the camera menus. To activate image stabilization, slide the O.I.S. switch to [ON].
O.I.S. switch
Slide the focus ring to the front for autofocus.
For manual focus, slide the focus ring to the back and rotate it while checking the results in the camera display. The focus distance and depth-of-field indicators can be used to assist manual focus.
The Depth-of-Field Indicator
The depth-of-field indicator shows the approximate depth of field (the distance in front of and behind the focus point that appears to be in focus). The indicator is displayed in film format.
Note that manual focus may not be available in all shooting modes.
Use a blower to remove dust, then gently wipe with a soft, dry cloth. Any remaining stains can be removed by wiping gently with a piece of FUJIFILM lens-cleaning paper to which a small amount of lens-cleaning fluid has been applied. Replace the front and rear caps when the lens is not in use.
.
