The camera can be used with lenses for the FUJIFILM X-mount.
Focus ring
Zoom ring
Mounting marks
Lens signal contacts
Front lens cap
Rear lens cap
A XC15-45mmF3.5-5.6 OIS PZ is used here for illustrative purposes.
When ON is selected for TELECTRONIC ZOOM SETTING, the sub-command dial can be used to adjust zoom when the monitor is opened horizontally to approximately 180°.
The focus ring can be used to adjust zoom when autofocus is enabled.
Remove lens caps as shown.
Lens caps may differ from those shown.
When attached, lens hoods reduce glare and protect the front lens element.
At settings other than A, you can adjust aperture by rotating the lens aperture ring (exposure modes A and M).
The Aperture Mode Switch
If the lens has an aperture mode switch, aperture can be adjusted manually by sliding the switch to Z and rotating the aperture ring.
Aperture ring
Aperture mode switch
When the aperture ring is set to A, rotate the sub-command dial to adjust aperture.
If the lens supports optical image stabilization (O.I.S.), the image stabilization mode can be chosen in the camera menus. To activate image stabilization, slide the O.I.S. switch to ON.
Slide the focus ring to the front for autofocus.
For manual focus, slide the focus ring to the back and rotate it while checking the results in the camera display. The focus distance and depth-of-field indicators can be used to assist manual focus.
Note that manual focus may not be available in all shooting modes.
The Depth-of-Field Indicator
The depth-of-field indicator shows the approximate depth of field (the distance in front of and behind the focus point that appears to be in focus). The indicator is displayed in film format.
Use a blower to remove dust, then gently wipe with a soft, dry cloth. Any remaining stains can be removed by wiping gently with a piece of Fujifilm lens-cleaning paper to which a small amount of lens-cleaning fluid has been applied. Replace the front and rear caps when the lens is not in use.