Enter a search term and click .

Adjust power management settings.


To access power management settings, press [MENU/OK], select the D ([SET UP]) tab, and choose [POWER MANAGEMENT].


[AUTO POWER OFF]

Choose the length of time before the camera turns off automatically when no operations are performed. Shorter times increase battery life; if [OFF] is selected, the camera must be turned off manually.

Options
[5 MIN] [2 MIN] [1 MIN] [30 SEC] [15 SEC] [OFF]

[PERFORMANCE]

Select [BOOST] to improve focus and EVF display performance.

Option Description
[BOOST]

Boost camera focus and EVF display performance. The battery drains faster than when is [NORMAL] selected.

You can choose to assign priority to:

  • [AF PRIORITY - NORMAL]: Focus speed.
  • [AF PRIORITY - LOW LIGHT]: Focus speed while adjusting EVF and LCD brightness to make objects in shadows easier to see. Some ghosting may be visible with blurred images.
  • [EVF RESOLUTION PRIORITY]: Viewfinder resolution.
  • [EVF FRAME RATE PRIORITY (120P)]: The refresh rate for the EVF is increased, smoothing motion.
  • [EVF FRAME RATE PRIORITY (240P EQUIV.)]: The refresh rate for the EVF is increased beyond [EVF FRAME RATE PRIORITY (120P)] smoothing motion still further. The EVF may darken.

Regardless of the option selected, the camera functions in [AF PRIORITY - NORMAL] mode while the monitor is on.

The D[SCREEN SET-UP] > [EVF FULL SCREEN MAGNIFICATION] setting cannot be changed when either [EVF FRAME RATE PRIORITY (120P)] or [EVF FRAME RATE PRIORITY (240P EQUIV.)] is set. With these settings, the screen magnification is set to 0.77x.

[NORMAL] Choose for standard focus and EVF display performance and battery endurance.

[SHOOTING STAND BY MODE]

Choose the delay before the camera enters shooting standby mode.

Option Description
[5 MIN] The camera will suspend all functions and enter powering-saving (standby) mode if no operations are performed for the selected period.
[2 MIN]
[1 MIN]
[30 SEC]
[15 SEC]
[OFF] Shooting standby mode disabled.

[AUTO POWER SAVE]

If [ON] is selected, the display frame rate will drop to save power if no operations are performed for a short period, but the normal frame rate can be restored by operating camera controls.

Options
[ON] [OFF]

[AUTO POWER OFF TEMP.]

If its temperature rises beyond a certain point, the camera will first display a message and then, if the temperature rise continues, automatically end shooting and power down. Choose the temperature at which the camera turns off automatically.

Option Description
[STANDARD] The camera turns off automatically when its temperature reaches the [STANDARD] value.
[HIGH] Shooting can continue at temperatures higher than the [STANDARD] value, extending the time available to record movies and the like. ecause remaining in contact with the camera at these high temperatures could result in low-temperature burns, this option should only be used after mounting the camera on a tripod or taking other steps to avoid prolonged contact with the camera.